Water Powered Brush 32 and 39in Jet Clearing Steps
Water Powered Brush Jet Clearing
This is a step by step guide to clearing a clogged jet in the water powered brushes.
![](/mmJRCNEW/images/content/1)-remove-the-brass-fitting-bvvcr1.jpg)
Remove the Brass Fitting from the Brush Assembly
It is not necessary to remove the bristles but removal can make it easier to hold the brush assembly
![](/mmJRCNEW/images/content/2)-remove-the-brass-fitting---out-s68nZ2.jpg)
Brass Fitting with Jet Removed from Assembly
Find an allen wrench that fits into the end of the Jet
![](/mmJRCNEW/images/content/3)-note-the-jet-in-end-of-fitting-DIEad3.jpg)
End View of Jet in Brass Fitting
![](/mmJRCNEW/images/content/4)-remove-the-jet-with-an-allen-wrench-zGQrq4.jpg)
Remove Jet from Brass Fitting
![](/mmJRCNEW/images/content/5)-jet-is-removed-from-the-brass-fitting-DIEad5.jpg)
Jet can now be cleared of the obstruction
![](/mmJRCNEW/images/content/6)-clearing-the-obstruction-push-from-smooth-side-out-to-threaded-end-zGQrq6.jpg)
Use a small brad, or similar strong thin metal pin
Puch the Bras into the smooth end of the Jet to puch the obstruction out of the Jet
![](/mmJRCNEW/images/content/7)-jet-obstruction-cleared-EkuhX7.jpg)
Brad has Cleared the Obstruction
![](/mmJRCNEW/images/content/8)-jet-reinstallation-into-brass-fitting-Smd7R8.jpg)
Re-install the Jet into the Brass Fitting
![](/mmJRCNEW/images/content/9)-attaching-m33-fitting-for-testing-CfKL49.jpg)
Attach to M22 Fitting and water source to Test
![](/mmJRCNEW/images/content/10)-testing-the-jet-n8gpi10.jpg)
Successful Testing
![](/mmJRCNEW/images/content/11)-re-install-the-brass-fitting-with-jet-cleared-into-brush-assembly-EkuhX11.jpg)
Re-install the Brass Fitting with Jet installed into the Brush Assembly
![](/mmJRCNEW/images/content/12)-hand-tighten-fittling-till-just-more-than-snug-Yu0Ma12.jpg)