F9 GroundsKeeper Concrete Cleaner 5 Gal

F9 GroundsKeeper Concrete Cleaner 5 Gal

F9 Groundskeeper SDS

F9 Groundskeeper is a high performance maintenance cleaner to use after your initial degreasing, pre-cleaning or just hot water washing. It is a buffered low pH product that will continue to brighten the surface and deep clean the surface every time it is applied. Unlike high PH products, the surfaces cleaned will stay cleaner longer and not get as dirty over time. This means you will use less product to clean the surface and at the same time increase your workspeed on the job.

Features:

• Reduces Time Spent On The Job
• Surface Stays Cleaner Longer
• Quickly Removes Contaminates
• Biodegradable
• Phosphate Free

Cleaning Instructions and How to Use Pre-Cleaning:

F9 GroundsKeeper (F9 GK) is a highly concentrated cleaner to use after your initial cleaning/degreasing. If existing oil and hydrocarbon stains are present, it is recommended to clean those stains with F9 Double Eagle Degreaser first. Once you can see the concrete pores below the stain then apply F9 GK to surface (at recommended dilution ratio) and surface clean. This will get the concrete set up for maintenance cleaning with F9 Groundskeeper. Dilution Ratios (Water to Product): For Use on Concrete, Bricks, Pavers, Most Tile, Stone, Grout and Masonry Hard Surfaces. Initial Cleaning: 8:1 to 10:1. Pre-wet surface with water and spray on. Use more concentrated for heavily soiled areas and less concentrated for less soiled areas. Always surface clean after application. Maintenance Cleaning: 10:1 to 20:1. Pre-wet surface with water and spray on. Use more concentrated for heavily soiled areas and less concentrated for less soiled areas. Always surface clean after application. Cleaning Instructions: Direct Application: Pump Sprayer, Electric or Air Diaphram Dilute F9 Maintenance Cleaner at recommended dilution ratios (Water to Product). Always add product to water, NOT water into product! Dilution will depend on how dirty the areas are. Product may be diluted up to 20:1. Dwell 2-10 minutes and surface clean. Brushing may be useful on stubborn areas. Downstream Application Downsream application is OK, but make sure final dilution of product is 10:1 up to 20:1 to meet dilution guidelines above. CAUTION! Never use F9 Groundskeeper undiluted or get undiluted product on porous surfaces. F9 Groundskeeper may etch surfaces at strong dilutions. ALWAYS perform a test to confirm compatibility.

Before/after photo of an area cleaned with F9 Groundskeeper vs. an area cleaned with high PH cleaner 20 days after cleaning: