Description

Micro Jet Rinse Bar 10in Gardiner

Allows for Rinsebar effect rinsing over the brush
Fully adjustable lockable angle - have the water hitting the glass/bristles exactly where you want it
Fits any brush with a Quick-LoQ socket
Takes two Fanjets to provide full brush width rinsing
Low profile design does not impact brush use
Robust impacting point
Lightweight - Rinsebar & Clamp weighs 18g
16 micro jets provide precise but gentle rinsing with brush on the glass
Fits between brush and brush socket on any standard width (26cm) Gardiner brush (not the Sill brush or Supreme)
Provides over-bristle micro jet rinsing
Flow rate is half that of the standard micro-jet rinse-bar and about equivalent to standard pencil or Fanjets - recommended 1.5 - 2lpm
Jet angle is 3° higher than standard rinsebar to allow for lower flow rates
Height of jets can be adjusted
Can be used with internal brush jets as well
Lightweight at 41g
Uses John Guest connections on unit
Uses standard Brush T Connector and jet hose - optional extra
Needs 2 longer screws to allow it to be attached between brush body and brush socket (if used on standard brushes, will need 19mm screws)
Please note: The rinse bar does not come with the brush & gooseneck pictured