ProTool 21" Vacuum Water Recovery Surface Cleaner

Designed for External Pump-Out Vacuum Systems

The ProTool 21" Vacuum Recovery Surface Cleaner is built for contractors who require full water containment using a dedicated vacuum reclaim system.

This model features a direct suction port designed to connect to an external wet vacuum with automatic pump-out capability.

If you're working in regulated commercial environments where water recovery is mandatory, this is the professional solution.

Requires External Vacuum System

This unit must be paired with a wet vacuum recovery system.

When connected to a vacuum system, it will:

✔ Extract wastewater, slurry, and debris
✔ Maintain strong suction regardless of slope
✔ Recover water on flat, uneven, or uphill surfaces
✔ Transfer wastewater directly to drain or holding tank
✔ Help meet strict municipal and EPA runoff regulations

Because recovery is powered by an external vacuum motor, suction remains consistent and independent of pressure washer flow.

21” Commercial Cleaning Performance

The 21-inch stainless steel housing delivers the ideal balance of productivity and maneuverability.

• Wide cleaning path for efficient coverage
• Even spray pattern to reduce striping
• Heavy-duty swivel casters
• Reinforced handle assembly
• Built for daily contractor use

Perfect for:

• Parking lots
• Storefronts
• Sidewalks
• Gas stations
• Municipal properties
• Industrial flatwork
• Parking garages

Performance Specifications (Surface Cleaner)

• Cleaning Width: 21 Inches
• Max Pressure: 4,000 PSI (275 Bar)
• Minimum Operating Pressure: 2,600 PSI (180 Bar)
• Minimum Flow Requirement: 4 GPM (15 LPM)
• Max Water Temperature: 140°F (60°C)
• Inlet: 3/8" Quick Connect Plug
• Nozzle Configuration: 2 × Size 20 Orifices
• Vacuum Port: Direct suction connection (No Venturi System)
• Recovery Hose: 5 Meter (16.4 ft) Included

Why Choose a Direct Vacuum Recovery Model?

Compared to venturi-style systems:

✔ Stronger and more consistent suction
✔ Works uphill and on uneven surfaces
✔ Handles heavier slurry loads
✔ Greater compliance for regulated job sites
✔ Ideal for high-volume commercial recovery

This model is designed specifically for contractors running full reclaim rigs with pump-out vacuums.

Important Note

This model does not create suction on its own.
A vacuum recovery system is required for operation.

If you are looking for a unit that does not require a vacuum on level ground, see our Venturi Recovery Model instead.

Recommended Pump-Out Vacuum System

Pairs perfectly with a 24-Gallon Industrial Wet Pump-Out Vacuum such as the IPC Eagle automatic discharge model.

Typical vacuum specifications:

• 1.5 HP Vacuum Motor
• 3 Amp Automatic Discharge Pump Motor
• 87" Water Lift
• 101 CFM Air Flow
• Automatic discharge rate up to 48 GPM
• Capable of 25 ft vertical lift
• Durable polyethylene tank
• 110V / 60Hz / 9 Amp
• 25 ft power cord
• Weight: 49 lbs

This type of pump-out system allows continuous recovery and automatic discharge without stopping to empty the tank — ideal for commercial flatwork and reclaim-required jobs.

Maximum control. Full reclaim capability. Built for commercial compliance.